Video transmitter VTX RushFPV XSPAN 3W 6.1G-7.2G, 64 channels

The RushFPV XSPAN video transmitter is a broadband FPV VTX for transmitting analog FM video signals in the 6100-7200 MHz range. The device supports 64 channels and several output power levels up to 3W, which allows you to configure the system for different operating conditions and transmission range.

The model is built on a high-frequency Rogers PCB using specialized PLL chips that ensure stable operation and accurate frequency retention. The built-in broadband power amplifier (PA) provides stable output power across the entire channel range.

The housing is made of aluminum alloy and is equipped with active cooling in the form of a turbine, which improves heat dissipation during operation at high power. The transmitter supports control via IRC Tramp Protocol and can be configured via a flight controller.

The kit uses a broadband omnidirectional antenna RUSHFPV 6.0-7.2GHz with coordinated characteristics for stable system operation.

Video transmitter specifications

Main characteristics

• Device type: analog FPV video transmitter (VTX)
• Signal type: FM
• Frequency range: 6100-7200 MHz
• Number of channels: 64CH
• Levels power:
  • PIT
  • 25mW
  • 200mW
  • 1W
  • 3W
• Output power:
  • PIT: -50dBm
  • 50mW: 17dBm
  • 200mW: 23dBm
  • 1W: 30dBm
  • 3W: 35dBm

Power

• Operating voltage: DC 7-30V
• Power connector: SH1.0 6Pin

Interfaces

• SMA 50 Ohm
• SH1.0 6Pin
• DATA (IRC Tramp)
• VIDEO
• DC-IN
• RGB LED + Button

Operating Temperature

• -10°C ~ +60°C

Control Protocol

• IRC Tramp

Dimensions and Weight

• VTX Dimensions: 44 × 28.6 × 14.7 mm
• VTX Weight: 24 g

Antenna Specifications

RUSHFPV 6.0GHz–7.2GHz Antenna

• Polarization Type: Linear
• Frequency Range: 6000-7200 MHz
• Radiation Type: Omni-directional
• Gain: ≤4.6 dBi
• V.S.W.R: ≤1.5
• Cable: RG402
• Connector: SMA Male
• Impedance: 50 Ohm Nominal
• Dimensions: H150 × W23 mm
• Weight: 9.6 g

Frequency table

Package

• Video transmitter X-SPAN 7.2GHz VTX
• Antenna RUSHFPV 6.0–7.2GHz
• Cable SH1.0 6Pin

Control and settings

The transmitter is controlled by one button with RGB backlight:

• Blue color - selection of the band (Band)
• Red color - selection of the channel (Channel)
• Green color - selection of the power level (Power)

RGB indication principle

In standby mode, the RGB LED flashes cyclically. The number of flashes corresponds to the current VTX setting.

To enter the settings menu:

1. Hold the button
2. Wait for the desired color
3. Release the button
4. Change the value with short presses

For settings via the flight controller, the DATA pin and the IRC Tramp protocol are used.

Important information

• The antenna must be installed before powering up the VTX.
• The complete antenna is already tuned to the operating range of the transmitter.
• Using an inappropriate antenna may degrade the signal quality or damage the transmitter.